Elmomc AC Input Digital Servo Drives-Bassoon Instrukcja Użytkownika Pobierz pdf (Strona 18)

Bassoon Installation Guide Installation

MAN-BASIG (Ver. 1.502)

www.elmomc.com

3.3. Assembling the Heatsink

When an external heatsink device is required, attach it with four screws to the left side of the

Bassoon, as depicted in the following diagrams.

BAS0033A

BAS0041A-DWG

Figure 3: Attaching the Heatsink

To mount the finned heatsink use M4 screws and spring washers. To mount the L-shaped

heatsink use conical head M4 screws.

3.4. Mounting the Bassoon

The Bassoon has been designed for two standard mounting options:

• Mounting on a DIN rail

• Attaching directly to a wall with screws

3.4.1. Mounting on a DIN Rail

At the top rear of the Bassoon, a horizontal groove lets you quickly and easily snap the drive

onto a DIN rail in your work area.

To mount the Bassoon on a DIN rail:

1. If the mounting tab is attached to the top of the Bassoon, remove it by pushing it down and

slipping it out of the slot (see the figure below).

2. Mount the upper slit on the back of the Bassoon on the upper edge of the DIN rail.

3. Tilt the bottom of the Bassoon towards the bottom of the DIN rail until you hear a click.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 68 69

Brak uwag

Elmomc AC Input Digital Servo Drives-Bassoon Instrukcja Użytkownika Strona 18